Bush for rear wheel carrier. Porsche 955 / 957 / 958 Cayenne >>2014  ❭  95534158810

Bush for rear wheel carrier
Genuine Porsche OE bush for the rear wheel carrier on selected Porsche 955, 957 and 958 Cayenne models. This original Porsche bonded rubber suspension bush fits within the rear wheel carrier / rear axle control arm assembly, helping locate the suspension correctly while absorbing road vibration and suspension movement.
Sold individually, 2 required per vehicle

Fits:
Porsche 955 Cayenne 2003 - 2006
Porsche 957 Cayenne 2007 - 2010

Porsche 958 Cayenne 2011 - 2014
 * not GTS and Turbo S version


Diagram ref No 20

This bush is used in the rear axle wheel carrier / control arm assembly on selected Porsche Cayenne models.

What This Part Does / Functions
•  Helps locate the rear wheel carrier correctly
•   Allows controlled movement within the rear suspension assembly
•   Absorbs road shock, vibration and harshness
•   Supports correct rear suspension geometry
•   Helps maintain rear wheel alignment stability
•   Reduces looseness, knocking and excess movement from worn suspension bushes
•   Provides correct OE Porsche fitment and rubber compliance
•   Replaces a worn, split, perished or loose original bush.

Why Replace This Part?
Rear wheel carrier bushes are exposed to road load, suspension movement, braking force, acceleration load, dirt, water and age-related rubber deterioration. Over time, the rubber can crack, split, soften or separate from the bonded sleeve. A worn bush can cause rear suspension play, knocking noises, vague handling, uneven tyre wear and poor alignment stability. Replacing the bush with a Genuine Porsche OE rear wheel carrier bush helps restore correct suspension control, factory ride quality and stable handling.

Common Symptoms of a Worn Rear Wheel Carrier Bush
•   Knocking or clunking from the rear suspension
•   Rear axle vibration or harshness
•   Uneven rear tyre wear
•   Poor rear wheel alignment stability
•   Rear-end wandering or instability
•   Excessive movement in the rear wheel carrier / suspension arm
•   Suspension noise over bumps
•   Failed MOT / roadworthiness inspection due to bush wear.

When to Replace This Part
•   If the original bush is cracked, split, perished or separated
•   If there is excessive play in the rear wheel carrier
•   During rear suspension overhaul or wheel carrier repair
•   If rear suspension knocking is traced to the bush
•   If rear wheel alignment cannot be held correctly
•   After kerb, pothole or impact damage
•   When replacing related rear suspension arms or hardware
•   When restoring the suspension with correct Genuine Porsche OE parts.

Where It Fits on the Car
This bush fits in the rear axle wheel carrier / rear suspension control arm area. It forms part of the rear suspension assembly and helps connect the wheel carrier/control arm arrangement to the vehicle’s suspension mounting points.

Professional installation is recommended, as the old bush normally needs to be pressed out and the new bush pressed in correctly. A wheel alignment should be checked after suspension work.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

95534158810

The product you are viewing cross references to these numbers