Fog/Drive Lamps

Fog light bracket.
Sold each - Two required per car

Fits:
Porsche 911 - 1969 to 1973
Porsche 912 1969

This is the bracket for the fog light through the chrome grille. 

Diagram ref no 19

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163113702

The product you are viewing cross references to these numbers

Fog light bracket.
This is the bracket for the fog light through the chrome grille. Two needed per car. Price is for each.

Fits:
Porsche 911 1969-73
Porsche 912 1969
Diagram ref no 19

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163113702

The product you are viewing cross references to these numbers

The 901 613 503 20 is a dashboard-mounted mechanical or push-pull switch used in early Porsche 911 / 911S / 911L and 912 models (1960s era) to activate the front fog lights. It is often grouped with the rear-window heating and warning-light switches, depending on vehicle specification.

In use, pulling or pressing the switch completes the circuit for the fog lights, sending power (via fuse and relay) to the fog lamp units. The switch usually has an internal light (“light-pipe”) or indicator so you can tell when fog lights are active. 

Fits:

• Porsche 911 65-68 + 911S, 912 USA version 911L with red lighting strip
• Porsche 911 1965-1968 2.0L / 912 SWB (F)
• Porsche 912E 4CYL 1976  

Why / when it should be replaced

·         Even though the fog light switch is a relatively simple component, there are several reasons why it might need replacing:

·         Internal wear or contact failure. Over time, the internal contacts inside the switch can wear, corrode, or lose tension, leading to poor electrical contact. If that happens, the fog lights may not activate when the switch is engaged.

·         No illumination of the switch itself. On models where the switch includes a light-pipe or internal lamp so that you can see the switch position, failure of that internal illumination can make it harder to know whether the fog lights are on and may indicate internal switch failure.

·         Switch stuck or mechanically broken. The pull/knob mechanism may become sticky, stuck, or physically break, especially after decades of use, or due to heat/cockpit environment ageing. A switch that doesn’t move properly or won’t stay in the “on” position cannot reliably activate the fog lights.

·         Intermittent operation / flickering. Even if the switch appears to work, intermittent contact inside the switch might cause the fog lights to flicker, drop out, or not turn off properly.

·         Fuse or wiring feedback problems. In some cases, a failing switch can lead to blown fog-light fuses or feedback to wiring loops, especially if there is an internal short or poor contact. Replacing the switch may be required after troubleshooting electrical issues.

Diagram ref no 13

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90161350320

The product you are viewing cross references to these numbers

Fog Light, left / right chrome, with clear glass, type Hella 118, with bulb, with e-mark.



Fits:
Porsche 911 2.0-2.4 01/63-07/73
Porsche 912 1.6 01/65-02/70
Porsche 914 1.7-2.0 01/69-02/76

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

1695200502

The product you are viewing cross references to these numbers

Fog Light, left/right chrome, with yellow glass, type Hella 118, with bulb, with e-mark.



Fits:
Porsche 911 2.0-2.4 01/63-07/73
Porsche 912 1.6 01/65-02/70
Porsche 914 1.7-2.0 01/69-02/76

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163120210

The product you are viewing cross references to these numbers

Front bumper fog lamp hole cover. 

Fits:
Porsche 911 1965-73

Diagram ref no. 34.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90250505

The product you are viewing cross references to these numbers

Front carbon fibre light pod unit.



Fits:
Porsche 911 - 1965 to 1989
Porsche 964 - 1989 to 1994

High quality carbon fibre light pod and cover as fitted to the 911 SC RS.

The Porsche factory race department used the four lamp pod starting after 1978. Rather than installing the single light units, they determined they could save weight, increase lamp count to four, and have a unit that could be removed quickly.

Front fibreglass light pod unit. Porsche 911 / 964



Fits:
Porsche 911 - 1965 to 1989
Porsche 964 - 1989 to 1994

High quality fiberglass light pod and cover as fitted to the 911 SC RS.

The Porsche factory race department used the four lamp pod starting after 1978. Rather than installing the single light units, they determined they could save weight, increase lamp count to four, and have a unit that could be removed quickly.

Additional Front Fog Lamp Lens 
Sold each

Restore the appearance and performance of your classic Porsche lighting system with this OE Match Additional Front Fog Lamp Lens for the Porsche 911 (1965-1977). Manufactured to  the original factory specification, this direct replacement  delivers the correct fit, clarity and factory-style appearance for your additional front fog lamp assembly.

Fits:

• Porsche 911 1965-1968 2.0L / 912 SWB (F)
• Porsche 911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)
• Porsche 911 1974-1977 2.7L / 1976-77 3.0 Carrera
• Porsche 911 1978-1983 3.0L / SC
• Porsche 911 1975-1977 3.0L Turbo (930)

The fog lamp lens is designed to protect the internal reflector and bulb while ensuring the correct light distribution for improved visibility in poor weather conditions. Whether you're replacing a damaged lens or completing a concours-quality restoration, this OE Match component restores both safety and originality to your Porsche 911.

What Does the Additional Front Fog Lamp Lens Do?

The fog lamp lens is an important part of the auxiliary lighting system.

Its primary functions include:

• Protecting the fog lamp reflector and bulb from water, dirt and road debris.
• Directing and diffusing the fog lamp beam correctly.
• Improving visibility during fog, rain and poor weather conditions.
• Helping maintain the weatherproof integrity of the fog lamp assembly.
• Preserving the original appearance of the front lighting system.

A clear, undamaged lens is essential for maximum light output and correct beam performance.

Why Does the Fog Lamp Lens Need Replacing?

Mounted low on the front of the vehicle, fog lamp lenses are constantly exposed to harsh road conditions.

Common causes of deterioration include:

• Stone chips from road debris.
• Cracks caused by minor impacts.
• Surface scratches and pitting.
• UV exposure causing clouding or discolouration.
• Moisture ingress through damaged glass.
• General ageing after decades of service.

A damaged lens can significantly reduce light output and allow moisture to damage the reflector and internal components.

When Should It Be Replaced?

Replacement is recommended when:

• The lens is cracked or chipped.
• The glass has become cloudy or heavily scratched.
• Water or condensation is present inside the fog lamp.
• Light output has noticeably reduced.
• Restoring the vehicle's front lighting system.
• Completing a concours or factory-correct restoration.

Replacing the fog lamp lens helps restore optimum lighting performance while maintaining the authentic appearance of your classic Porsche.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163121100

The product you are viewing cross references to these numbers

Lens for fog lamp, clear.



Fits:
Porsche 911 2.0-2.4 01/63-07/73

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163121103

The product you are viewing cross references to these numbers

Protection cover set additional driving light Cibie style.
Sold as a pair

Fits:
Porsche 911 - 1965 to 1989

Protection / lamp cover set for the Cibie style driving lamp pair with E-mark.

The Cibie driving lamps / auxiliary headlights provide additional illumination of the road and for an optimal visibility at night. The halogen headlight additionally convinces with its classic look These additional driving lamps are suitable for left-hand drive Porsche 911 F model and G model.  

Reflector lens for Rear 1/4 bumper.

Fits:
Porsche 911 1966-73

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163301000

The product you are viewing cross references to these numbers

Reflector On Bumper Rear, In 1/4 Rubber.
The OE Match Rear Bumper Reflector in Quarter Rubber is a premium-quality replacement exterior lighting and trim component designed to restore the original appearance and rear visibility of compatible classic Porsche models. Manufactured to OE specifications for fit, finish and durability, this precision-engineered reflector is designed to mount within the rear bumper quarter rubber, providing passive rear visibility while preserving the authentic factory styling of the vehicle.  

Fits:

• Porsche 911 1965-1968 2.0L / 912 SWB (F)
• Porsche 911 1968-1973 2.2L / 2.4L / 2.7L RS LWB (F)  

Manufactured using high-quality automotive-grade reflective material with a durable UV-resistant lens and weather-resistant housing, the reflector is engineered to withstand prolonged exposure to sunlight, moisture, road debris and temperature extremes without fading, cracking or losing its reflective properties. Precision-manufactured to replicate the original Porsche dimensions, it provides direct OE-style installation, making it ideal for restoration projects, accident repairs or replacing damaged or missing original reflectors.  

What This Product Does:

• Provides passive rear visibility by reflecting light from following vehicles.
• Mounts securely within the rear bumper quarter rubber.
• Enhances vehicle visibility in low-light conditions.
• Helps improve road safety when parked or driving at night.
• Restores the original appearance of the rear bumper.
• Replaces faded, cracked or missing reflectors.
• Maintains factory exterior styling.
• Forms an essential part of the vehicle's rear safety and trim system.

Symptoms Of Wear Or Failure:

• Cracked or broken reflector lens.
• Faded or discoloured reflective surface.
• Reduced reflectivity at night.
• Loose or missing reflector.
• Water ingress behind the reflector.
• Scratches or impact damage.
• Poor appearance of the rear bumper.
• Damaged mounting points.
• Reduced vehicle visibility to other road users.
• MOT or vehicle inspection advisory due to damaged reflector.

Why Replacement Matters:

• Rear reflectors play an important role in passive vehicle safety by making the vehicle more visible to other road users in low-light conditions. Over time, exposure to UV rays, moisture, road debris and minor impacts can cause the reflector to fade, crack or become detached, reducing its effectiveness and detracting from the vehicle's appearance.
• A damaged or missing reflector reduces rear visibility and may result in MOT or roadworthiness issues, depending on the vehicle's condition. It can also compromise the authentic appearance of a classic Porsche, particularly during restoration or concours preparation.
• Replacing the original component with the OE Match Rear Bumper Reflector in Quarter Rubber restores both safety and originality. Manufactured to OE standards using premium-quality reflective materials, it provides factory-style fitment, excellent weather resistance and long-lasting durability, ensuring your Porsche retains its correct appearance and remains clearly visible in all driving conditions.

Related reference numbers
Related, superseded, cross reference or alternative numbers for comparison.

90163301000

The product you are viewing cross references to these numbers